Then follow the steps to get around the setup wizard and then follow these steps before anything else: Well, if you're already stuck in this endless loop, press the reset button to reset the router configuration to the defaults. If you go ahead and make all your changes and close the browser, you'll be stuck! The changes you made wouldn't have taken effect and if you try to visit to configure the router again, you will automatically be redirected to, which will fail to open. Now you will see the familiar setup page. To skip the setup wizard and go straight to the configuration interface, change the URL in your browser to. This is, to say the least, very annoying and very bad design. This wizard looks for an Internet Connection and if it doesn't find one, it will put you in an endless loop, bringing you back to the start of the wizard until you have an internet connection available. When you open a web browser and visit you are redirected to. This allows you to plug in a computer and get an IP address from the router so you can connect to the web-based configuration interface. When you plug in and turn on the Netgear router for the first time, it is configured with an IP address of 192.168.1.1 and, as usual, DHCP is enabled. ![]() ![]() Update: Visitors have notified me that his solution also works with the following models: If you discover this information applies to other Netgear models, I would appreciate it if you leave a comment about that model. It may also apply to other models, but I have only tested these steps with the WGR614 v6. This information applies to the Netgear model WGR614 v6.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |